视频

How to install acrylic hot wheel rack

1. Identify the staircase and support.
2. insert the staircase into the slot in support
3. make sure the bottom (no slot hole) is at the bottom
4. repeat until it’s done!

Category by Installation Tutorial

How to install Self Assembly Acrylic Cabinet

1. Identify the Plates name, TOP LEFT RIGHT BOTTOM FRONT BACK
2. Remove the protective sticker.
3. Screws the connector to acrylic correctly based on their name.
4. IMPORTANT: MAKE SURE DO NOT SCREW TOO TIGHT.
5. Before screw TOP plates, install the door aluminium (If you are buying sliding door version)
6. Put in the door, only screws the TOP PLATES
7. Tighten all the screws. DONE.

Category by Installation Tutorial

How to install Self Assembly Lucky Draw Box

1. Identify the plate name
2. Peel off the sticker and assemble following the plate name
3. Screw the interconnector in the inside of the box. The screws should be at the outside. (Make sure it is not tight when screw)
4. Make sure all the plates are assemble correctly, tighten the screws with a screwdriver.

Category by Installation Tutorial

How to Install (Hanging type)House Number Plate

• Use the given acrylic to do marking
• Drill hole with 6mm drill bit
• Install the screw anchor
• Install the screws (leave some space from the wall)
• Hang the signage

Category by Installation Tutorial

How to Install with Signage with tape

• Clean the wall (Make sure no dust)
• Make sure the surface is flat and smooth
• Peel off the tape cover
• Align to correct position and stick on your wall
• Press it for 5 seconds to improve adhesion

Category by Installation Tutorial

How to Install with Screws and Sign Spacers

• Marking the holes to drill on wall.
• Use 6mm drill bit to drill holes on wall.
• Insert the screws anchor.
• Screws the sign spacers into the wall
• Lock the signage/ house number plate using the sign spacer

Category by Installation Tutorial

Installing a Solar Lamp on House Number Plate

• Use the screws given to install the lamp on the plate
• Make sure the holes are correct.
• Can use double sided acrylic tape to install too, result will be as stable as using screws.
• Remember to turn on the lamp before install.

Category by Installation Tutorial

How to turn on the solar lamp for house number plate

• Use the given pin to poke the hole on the lamp
• If pin is missing, can use handphone pin / any pin to poke too.
• Once turn on, it should light up in dim environment and turn off when under sunlight (the solar panel is Charging battery)
• Remember to turn on the lamp before install the house number plate on your wall.

Category by Installation Tutorial