Technical data
| General Specifications | |
| Sensing distance | 30…400mm |
| Adjustment range | 50…400mm |
| Unusable area | 0…30mm |
| Standard target plate | 100mm×100mm |
| Transducer frequency | About 310kHz |
| Response delay | About 50ms |
| Indicators/Operating means | |
| LED blue | Power on |
| LED yellow |
indication of the switching state Flashing:program function object detected |
| LED red |
permanently red: Error Red,flashing:program function,object not detected |
| Electrical specifications | |
| Operating voltage U B | 10…30VDC,ripple10%ss |
| No-load supply current | ≤30mA |
| Input | |
| Input type |
1 TEACH-IN input Operating distance A1:-U B …+1V,operating distanceA2:+6… + U B Input impedance:＞4.7KΩ TEACH-IN programmable pulse :≥1S |
| Output | |
| Output type | 1 switch output E5,PNP NO/NC,programmable |
| Rated operational current | 100mA,short-circuit/overload protected |
| Default setting | Switching point A1:70mm Switching point A2: 800mm |
| Voltage drop | ≤ 3V |
| Repeat accuracy | ≤ 1% |
| Switching frequency f | ≤ 8 HZ |
| Range hysteresis H | 1% of the set operating distance |
| Temperature influence | ± 1.5% of full-scale value |
| Ambient conditions | |
| Ambient temperature | -25…70℃(248...343K) |
| Storage temperature | -40…85℃(233...358K) |
| Mechanical specifications | |
| Protection grade | IP67 |
| Connection | V1 connector(M12×1),4-pin |
| Material Housing | brass,nickel-plated |
| Transducer |
epoxy resin/hollow glass sphere mixture; Polyurethane foam |
| Weight | 25g |
Dimension
Adjusting the switching points
The ultrasonic sensor features a switch output with two teachable switching points. These are set by applying the supply voltage - U B or + U B to the TEACH-IN input. The supply voltage must be applied to the TEACH-IN input for at least 1s.LEDs indicate whether the sensor has recognised the target during the TEACH-IN procedure. Switching point A1 is taught with - U B ,A2 with +U B. Five different output functions can be set.1. Window mode, normally-open function.
2. Window mode, normally-closed function.
3. One switching point,normally-open function
4. One switching point,normally-closed function.
5. Detection of objet presence.
Switching point, Setting distance only after power on. The internal clock can assure can't be changed after 5 mins when power
on. If want to change the switching point, the user can only setting the request distance after power restart.
US 15671 
GB 11328 
CA 9005 
AU 6203 
IE 2530 
IN 1326 
SG 1218 
NZ 839 
